Senco PC2016 Operations Instructions download pdf (Page 12)

12 Senco

Electric Air Compressor Manual 2004

TROUBLESHOOTING

1. Motor will not run or restart.

REMEDY

Plug cord into grounded outlet.

Move switch to "AUTO" position.

Turn air compressor off, wait until motor is cool, then

press motor thermal overload (red) button ﬁrmly until

click is heard.

Replace fuse or reset circuit breaker.

Check for proper fuse; only "Fusetron" type T fuses

are acceptable.

Check for low voltage conditions.

Disconnect any other electrical appliances from

circuit or operate air compressor on its own branch

circuit.

Check chart on page #10 for proper gauge wire and

cord length.

When pilot valve is set in the Start/Stop position,

motor will start automatically when air tank pressure

drops below "cut-in" pressure of motor/pressure

switch.

Bleed the line by moving the switch to the "Off" posi

tion.

Remove and clean or replace.

Contact Senco Customer Service @ 800-543-4596

PROBABLE CAUSE

Power cord not plugged in.

Motor/Pressure switch in "OFF" position.

Motor thermal overload switch has tripped.

Fuse blown or circuit breaker has tripped.

Wrong gauge wire or length of extension cord.

Air tank pressure exceeds motor/pressure switch

"cut-in" pressure.

Pressure release valve on motor/pressure switch has

not unloaded pump head pressure.

Pilot valve's check valve stuck open.

Defective motor, motor capacitor or motor/pressure

switch.

SYMPTOM

2. Noisy operation.

REMEDY

Tighten pulley and or ﬂywheel.

Add correct amount of oil. Check for bearing dam-

age.

Remove cylinder head and inspect. Clean or re-

place.

STOP THE COMPRESSOR! Contact Senco

Customer Service @ 800-543-4596.

PROBABLE CAUSE

Loose motor pulley or pump ﬂywheel.

Lack of oil in the pump.

Carbon deposits on pistons or valves.

Bearing, piston or connecting rod failure.

SYMPTOM

1 2 ... 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Senco PC2016 Operations Instructions Page 12

Comments to this Manuals